Keysight U1231A - Figure 3-8 Empty View Display

Multimeter Features 3
Recalling Previously Recorded Readings (Recall)
U1231A/U1232A/U1233A User’s Guide 75
Figure 3-8 Empty view display
2 Use the following steps to navigate the Recall menu.
i Press to jump to the last stored entry, or press and
hold for more than 1 second to jump to the first
stored entry.
ii Press to view the next stored entry or press
to view the previous stored entry. The index number
(shown by the analog bar graph) increases or decreases
by one.
iii Press for more than 1 second to permanently
store all data entries in the multimeter’s nonvolatile
memory. is shown on the display if the data
entries are successfully stored.
iv Press for more than 1 second to clear the
temporary data entries. is shown on the display if
the data entries are successfully cleared. Cycle the
multimeter’s power again to view the permanent data
entries.
3 Press for more than 1 second to exit the Recall
menu.
Max
Min
Max
Min
A
u
to
R
a
n
g
e
N
u
l
l
R
e
c
a
l
l
A
u
t
o
T
ri
H
o
l
d
g
L
o
g
S
h
i
f
t
E
s
c
NOTE
To clear the permanent data entries
1 Press for more than 1 second until is shown on the display.
2 Then, press for more than 1 second until is shown on the display.
3 All data entries stored in the multimeter’s nonvolatile memory will be erased.
S
h
i
f
t
E
s
c
A
u
t
o
T
r
i
H
o
l
d
g
L
o
g
N
u
l
l
R
e
c
a
l
l