Keysight U2020 X Series - High Average Count Reset; Figure 2-27 Pulsed Radar Analysis - 20 Th Pulse

2 General Operating Information
64 Keysight U2020 X-Series User’s Guide
Figure 2-27 Pulsed radar analysis – 20th pulse
High average count reset
When high averaging factors have been set, any rapid adjustments to the
amplitude of the measured signal will be delayed due to the need to allow the
averaging filter to fill before a new measurement can be taken at a stable power
level. The U2020 X-Series allows you to reset the long filter after the final
adjustment to the signal's amplitude has been made.
TRAC:MEAS:TRAN20:POS:DUR?
(rise time of 20th pulse)
TRAC:MEAS:TRAN20:NEG:DUR?
(fall time of 20th pulse)
TRAC:MEAS:PULS20:DUR?
(pulse duration of 20th pulse)
NOTE
Refer to the U2020 X-Series Programming Guide for more information.