Need help?Do you have a question about the Keysight U8480 Series and is the answer not in the manual?
General| Type | Thermocouple Power Sensor |
|---|---|
| Sensor Type | Thermocouple |
| Impedance | 50 ohms |
| Calibration Interval | 1 year |
| Zeroing | Automatic zeroing |
| Storage Temperature | -40°C to 70°C |
Procedure for zeroing and calibrating the instrument to ensure accurate power measurements.
Guides on programming the instrument for measurements using high-level commands and queries.
Configures upper and lower limit values to detect out-of-specification measurements.
Discusses factors influencing the instrument's speed of operation and measurement rates.
Explains how to monitor instrument status by configuring and reading status registers.
Sets measurement parameters such as expected power level and resolution.
Calculates and sends measurement results to the PC.
Configures, makes a power measurement, and returns the result.
Setting the measurement rate (Normal, Double, Fast).
Querying error numbers and messages from the U8480 Series error queue.
Configuring the trigger system to respond to a specified source.
Examples of measuring CW power in Free Run and Single Trigger modes.
Example of performing a frequency sweep measurement.
Example of performing a power sweep measurement.
Examples of calculating Measurement Uncertainty with different Gamma types.
To Next Page
