Keysight U8480 Series User Manual

6 MEMory Subsystem
140 U8480 Series Programming Guide
MEMory:CLEar Commands
These commands are used to remove the frequency-dependent offset tables,
Gamma tables, the S-Parameter table, and save/recall registers. This command
subsystem removes the data contents but does not affect the name of the
associated table or save/recall register.
The following commands are detailed in this section:
MEMory:CLEar[:NAME] <“character_data”>
MEMory:CLEar:TABLe
NOTE
The contents cleared using these commands are non-recoverable.

Keysight U8480 Series Specifications

General

Brand	Keysight
Model	U8480 Series
Category	Accessories
Language	English