8 SENSe Subsystem
178 U8480 Series Programming Guide
[SENSe[1]:]AVERage Commands
These commands control the measurement averaging which is used to improve
measurement accuracy. They combine successive measurements to produce a
new composite result.
The following commands are detailed in this section:
[SENSe[1]:]AVERage:COUNt <numeric_value>
[SENSe[1]:]AVERage:COUNt:AUTO <boolean>
[SENSe[1]:]AVERage:SDETect <boolean>
[SENSe[1]:]AVERage[:STATe] <boolean>
To Next Page
Loading...