Keysight U8480 Series - CALCulate[1]:LIMit Commands

CALCulate Subsystem 3
U8480 Series Programming Guide 97
CALCulate[1]:LIMit Commands
These commands set the measurement limits which enable you to:
– set upper-level and lower-level limits
– query if there has been a failure
– count the number of failures
– clear the counter
The following commands or queries are detailed in this section:
CALCulate[1]:LIMit:CLEar:AUTo <boolean>|ONCE
CALCulate[1]:LIMit:CLEar[IMMediate]
CALCulate[1]:LIMit:FAIL?
CALCulate[1]:LIMit:FCOunt?
CALCulate[1]:LIMit:LOWer[:DATA] <numeric_value>
CALCulate[1]:LIMit:UPPer[:DATA] <numeric_value>
CALCulate[1]:LIMit:STATe <boolean>