Keysight U8480 Series - [Sense[1]:]Correction:cset4:[Select] <String

SENSe Subsystem 8
U8480 Series Programming Guide 219
[SENSe[1]:]CORRection:CSET4:[SELect] <“string”>
This command is used to select the S-Parameter table to be used for S-Parameter
correction.
Syntax
Query
[SENSe[1]:]CORRection:CSET4:[SELect]?
The query returns the currently selected S-Parameter table used for S-Parameter
correction.
If no table is selected, the query returns an empty string.
Query example
Error message
– If the string is not valid, error –224, “Illegal parameter value” occurs.
– If a table does not exist, error –256, “File name not found” occurs.
– When an S-Parameter table is selected, the power sensor verifies that the
number of magnitude-phase pairs defined for S11, S12, S21, and S22 is equal
to the number of frequency points defined. If they do not match, error –226,
“Lists not the same length” occurs.
SENS
1
:CSET4
CORR
:
?
:SEL
“string”
Space
CORR:CSET4:SEL? Queries the current table used in the S-Parameter
correction.