Keysight U8480 Series - Fetch[1][:Scalar][:Power:ac]? [<Expected

To Next Page

To Previous Page

MEASurement Commands 2

U8480 Series Programming Guide 79

FETCh[1][:SCALar][:POWer:AC]?

[<expected_value>[,<resolution>[,<source list>]]]

This command sets the measurement function, recalculates the measurement,

and places the result on the bus. The result is a power-based measurement and is

expressed in the units defined by UNIT[1]:POWer.

Refer to “Auto-Averaging Settings” on page 374 to configure the correct

parameters for the expected power and resolution.

Syntax

Parameters

Refer to “Optional parameters” on page 73 for additional details on the

parameters in this command.

:POW

:AC

:SCAL

Space

expected_value

DEF

resolution

DEF

source list

FETC

Item Description/Default Range of values

expected_value The expected power level parameter can be set to DEF or a

numeric value. If a value is entered, it should correspond to

that set by CONFigure otherwise an error occurs. The units of

measurement are dBm and W. The default units are defined by

UNIT:POWer.

sensor-dependent

DEF

[a]

Keysight U8480 Series - Fetch[1][:Scalar][:Power:ac]? [<Expected_Value>[,<Resolution>[,<Source List>]]]