MEASurement Commands 2
U8480 Series Programming Guide 73
Optional parameters
CONFigure, FETCh?, READ?, and MEASure? have the following three optional
parameters:
– An expected power value
–A resolution
– A source list
Refer to “Auto-Averaging Settings” on page 374 to configure the correct
parameters for expected power and resolution.
Expected power value
The <expected_value> parameter sets the expected power level of the
measurement.
Resolution
The <resolution> parameter sets the resolution of the measurement. This
parameter does not affect the resolution of the returned data, but it does affect
the auto-averaging setting.
Source list
The <source list> parameter is used to define the measurement channel.
To Next Page
Loading...