CALCulate Subsystem 3
U8480 Series Programming Guide 101
CALCulate[1]:LIMit:FAIL?
This query enters a 1 or 0 into the output buffer indicating whether there have
been any limit failures. A limit failure is defined as CALCulate[1]:LIMit:FCOunt?
being non-zero. The FCO (fail counter) can be zeroed using the
CALCulate[1]:LIMit:CLEar command.
– 1 is returned when one or more limit failures have occurred
– 0 is returned when no limit failures have occurred
Syntax
Example
Reset condition
On reset, the buffer is set to zero.
CALC:LIM:FAIL? Queries if there have been any limit failures.
To Next Page
Loading...