Keysight U8480 Series - Configure[1][:Scalar][:Power:ac] [<Expected_Value>[,<Resolution>[,<Source List>]]]

2 MEASurement Commands
76 U8480 Series Programming Guide
CONFigure[1][:SCALar][:POWer:AC]
[<expected_value>[,<resolution>[,<source list>]]]
This command is used to set:
– the expected measurement power level.
– the measurement resolution.
Refer to “Auto-Averaging Settings” on page 374 to configure the correct
parameters for the expected power and resolution.
Syntax
Space
expected_value
DEF
resolution
,
:POW
:AC
:SCAL
DEF
source list
,
CONF
1