Keysight U8480 Series - Trigger[:Sequence[1]]:Count <Numeric_Value

12 TRIGger Subsystem
320 U8480 Series Programming Guide
TRIGger[:SEQuence[1]]:COUNt <numeric_value>
This command controls the path of the trigger subsystem in the upward traverse
of the wait-for-trigger state. COUNt loops through the event detection/
measurement cycle performed. That is, COUNt measurements are performed in
response to COUNt trigger events.
COUNt can be set to a value of >1 only when [SENSe[1]:]MRATe
<character_data> is set to FAST.
Syntax
Parameters
Example
Reset condition
On reset, the value is set to 1.
Item Description/Default Range of values
numeric_value
The number of triggered events for the measurement cycle.
– DEF: The default value is 1
1 to 100
DEF
TRIG:COUN 10 This command sets the number of triggered events to 10
for the U8480 Series measurement cycle.
:COUN Space
?
numeric_value
DEF
TRIG
:SEQ
1