Keysight U8480 Series - Memory:table:gain[:Magnitude] <Numeric_Value>{,<Numeric_Value

MEMory Subsystem 6
U8480 Series Programming Guide 159
MEMory:TABLe:GAIN[:MAGNitude]
<numeric_value>{,<numeric_value>}
This command is used to enter offsets into the frequency-dependent offset table,
currently selected using MEMory:TABLe:SELect. Any previous offset list is cleared
before the new offsets are stored.
A maximum of 80 parameters for frequency-dependent offset tables can be sent
with this command.
Entries in the frequency lists correspond as shown in Table 6-4 with entries in the
offset factor lists.
Table 6-4 Frequency and offset factor list
Syntax
Parameters
Frequency Offset
Frequency 1 Offset 1
""
Frequency 80 Offset 80
Item Description/Default Range of values
numeric_value A numeric value for the offset factor. The unit is PCT. 1.0 to 150.0
MEM
:TABL
:GAIN
:MAGN
numeric_value
Space
,
?