6 MEMory Subsystem
160 U8480 Series Programming Guide
Example
Query
MEMory:TABLe:GAIN[:MAGNitude]?
The query returns a list of offset points for the currently selected table.
Query example
Error messages
– If more than 80 offsets for the frequency-dependent offset tables are in the list,
error –108, “Parameter not allowed” occurs.
– If a table is not specified using the MEMory:TABLe:SELect command, the data
cannot be entered and error –221, “Settings conflict” occurs.
– If any of the offset factors are outside of the allowed range, error
–222, “Data out of range” occurs.
MEM:TABL:SEL “Sensor_1”
MEM:TABL:GAIN 97,99.5,97.4
This command enters a reference offset
factor of 97%, 99.5%, and 97.4% into the
frequency-dependent offset table.
MEM:TABL:GAIN? Queries the offset in the current table.
To Next Page
Loading...