TRIGger Subsystem 12
U8480 Series Programming Guide 303
INITiate[1][:IMMediate]
This command sets the U8480 Series in the wait-for-trigger state. When a trigger
is received, the measurement is taken and the result is placed in the U8480 Series
memory. If TRIGger[1]:SOURce is set to IMMediate, the measurement begins as
soon as INITiate[1][:IMMediate] is executed.
Use FETCh? to transfer a measurement from memory to the output buffer. Refer to
“FETCh[1]? Query” on page 78 for further details.
Syntax
Example
Error message
If the U8480 Series is not in the idle state or INITiate[1]:CONTinuous is ON, error
–213, “INIT ignored” occurs.
This command performs the same function as
INITiate[1][:IMMediate]:SEQuence[1].
INIT This command places the U8480 Series in the wait-for-trigger
state.
To Next Page
Loading...
Need help?
General
