Keysight U8480 Series - [Sense[1]:]Detector:function <Character_Data

8 SENSe Subsystem
220 U8480 Series Programming Guide
[SENSe[1]:]DETector:FUNCtion <character_data>
This command is used to set the measurement mode for the U8480 Series to
AVERage (chopper-based measurement).
When AVERage is set, the following events occur:
–If TRIGger:SOURce is set to EXTernal, it is set automatically to IMMediate.
– INITiate:CONTinuous is set automatically to ON.
– CALCulate:FEED is set automatically to “POW:AVER” for the CALC block.
Syntax
Parameters
Example
Item Description/Default Range of values
character_data
Defines the measurement mode:
– AVERage: sets the U8480 Series to the average only
mode
AVERage
DET:FUNC AVER Sets the U8480 Series to the average only mode.
SENS
1
:FUNC
DET
:
Space
?
character_data