12 TRIGger Subsystem
324 U8480 Series Programming Guide
TRIGger[:SEQuence[1]]:IMMediate
This command provides a one-time override of the normal process of the
downward path through the wait-for-trigger state. It causes the immediate exit of
the event detection layer if the trigger system is in this layer when the command is
received. In other words, the U8480 Series stops waiting for a trigger and takes a
measurement ignoring any delay set.
Syntax
Example
TRIG:IMM This command initiates a measurement on the U8480 Series.
To Next Page
Loading...