Keysight U8480 Series - Trigger Commands

12 TRIGger Subsystem
310 U8480 Series Programming Guide
TRIGger Commands
TRIGger commands control the behavior of the trigger system.
The following commands are described in this section:
TRIGger[1]:DELay:AUTO <boolean>
TRIGger[1][:IMMediate]
TRIGger[1]:SOURce BUS|EXTernal|HOLD|IMMediate
TRIGger[:SEQuence]:DELay <numeric_value>
TRIGger[:SEQuence]:SLOPe <character_data>
TRIGger[:SEQuence[1]]:COUNt <numeric_value>
TRIGger[:SEQuence[1]]:DELay:AUTO <boolean>
TRIGger[:SEQuence[1]]:IMMediate
TRIGger[:SEQuence[1]]:SOURce BUS|EXTernal|HOLD|IMMediate