Keysight U8480 Series - [Sense[1]:]Average[:State] <Boolean

8 SENSe Subsystem
186 U8480 Series Programming Guide
[SENSe[1]:]AVERage[:STATe] <boolean>
This command is used to enable and disable averaging.
Syntax
Example
Reset condition
On reset, averaging is turned ON.
Query
[SENSe[1]:]AVERage[:STATe]?
The query enters a 1 or 0 into the output buffer indicating the status of averaging.
– 1 is returned when averaging is enabled
– 0 is returned when averaging is disabled
Query example
AVER 1 This command enables averaging.
SENS
1
AVER
:
:SDET
0|OFF
1|ON
Space
?
AVER? Queries whether averaging is enabled or disabled.