STATus Subsystem 10
U8480 Series Programming Guide 267
Operation Register Sets
The following registers contain information which is part of the U8480 Series
normal operation. The contents of the individual registers of these register sets
may be accessed by appending the commands listed in “Status Register Set
Commands” on page 262.
The following command descriptions detail the SCPI register you require to
control but do not detail the register set commands.
The seven operation register sets are:
STATUS:OPERation
STATus:OPERation:CALibrating[:SUMMary]
STATus:OPERation:LLFail[:SUMMary]
STATus:OPERation:MEASuring[:SUMMary]
STATus:OPERation:SENSe[:SUMMary]
STATus:OPERation:TRIGger[:SUMMary]
STATus:OPERation:ULFail[:SUMMary]
Further information on these register sets is provided on the following pages.
To Next Page
Loading...