Keysight U8480 Series - Calculate[1]:Feed[1] <String

CALCulate Subsystem 3
U8480 Series Programming Guide 95
CALCulate[1]:FEED[1] <“string”>
This command sets the input measurement mode to be fed to the specified input
on the CALC block. It is applied to the measurement after the
CALCulate[1]:MATH[:EXPRession] command has been used to specify which
measurement the feed is taken from.
Under certain circumstances, the measurement mode is changed by the
CALCulate[1]:MATH[:EXPRession] command. Refer to
“CALCulate[1]:MATH[:EXPRession] <“string”>” on page 111 for further
information.
Syntax
Parameters
Example
Item Description Range of values
string The input measurement type to be fed to the specific input on the CALC block
is AVER (average).
“POW:AVER”
CALC:FEED “POW:AVER” This command selects the input for FEED of
the CALC block to be average power. The
measurement from which the feed is taken is
determined by CALC:MATH:EXPR.
Space
?
“string”
:FEED
1
CALC
1