12 TRIGger Subsystem
300 U8480 Series Programming Guide
INITiate Commands
INITiate commands allow you to place the U8480 Series in the wait-for-trigger
state.
The INITiate commands are overlapped, that is, the U8480 Series can continue
parsing and executing subsequent commands while initiated. Note that the
pending operation flag is set when the U8480 Series moves out of the idle state,
and the flag is cleared when it re-enters the idle state.
The following commands are described in this section:
INITiate[1]:CONTinuous <boolean>
INITiate[1][:IMMediate]
INITiate[1]:CONTinuous:ALL <boolean>
INITiate[1]:CONTinuous:SEQuence[1] <boolean>
INITiate[1][:IMMediate]:ALL
INITiate[1][:IMMediate]:SEQuence[1]
To Next Page
Loading...