10 STATus Subsystem
274 U8480 Series Programming Guide
STATus:OPERation:ULFail[:SUMMary]
The operation status upper limit fail summary register set contains information on
the upper limit fail status of the U8480 Series.
The following bit in these registers is used by the U8480 Series:
Bit 1 is set if the upper limit test fails.
This bit is cleared if a measurement is made and the test is enabled and passes.
Syntax
Bit number Decimal weight Definition
0-Not used
12ULFail status
2 to 15 - Not used (bit 15 is always 0)
To Next Page
Loading...