Keysight U8480 Series - [SENSe[1]:]FREQuency[:CW|:FIXed] <numeric_value>

8 SENSe Subsystem
222 U8480 Series Programming Guide
[SENSe[1]:]FREQuency[:CW|:FIXed] <numeric_value>
This command is used to enter a frequency. The appropriate
frequency-dependent offset, Gamma, or S-Parameter corrections are applied for
the frequency selected, dependent on the frequency-dependent offset, Gamma,
or S-Parameter data stored in the non-volatile memory.
Syntax
Parameters
[a] The following measurement units can be used:
—Hz
—kHz (10
3
)
—MHz (10
6
)
—GHz (10
9
)
Item Description/Default Range of values
numeric_value
A numeric value for the frequency:
– DEF:The default value is 50 MHz
– MIN : 0 Hz
– MAX : 1000 GHz
The default unit is Hz.
0 Hz to 1000 GHz
[a]
DEF
MIN
MAX
:CW
Space
?
numeric_value
DEF
MIN
MAX
MIN
MAX
Space
SENS
1
FREQ
:
:FIX