Keysight U8480 Series - [Sense[1]:]Correction:cset3:State <Boolean

SENSe Subsystem 8
U8480 Series Programming Guide 215
[SENSe[1]:]CORRection:CSET3:STATe <boolean>
This command is used to enable or disable the Table-Based Gamma correction.
If this is enabled, gamma values from the currently selected Gamma table will be
used for correction.
Syntax
Reset condition
On preset (SYSTem:PRESet) and U8480 Series power-up,
[SENSe[1]:]CORRection:CSET3:STATe is set to OFF.
NOTE
This is mutually exclusive with the [SENSE[1]:]CORRection:SGAMma:STATe
command.
SENS
1
:CSET3CORR
:
:STAT
0|OFF
1|ON
Space
?