Keysight U8480 Series - Page 216

8 SENSe Subsystem
216 U8480 Series Programming Guide
Query
[SENSe[1]:]CORRection:CSET3:STATe?
The query returns the state of the Table-Based Gamma correction.
Query example
Error message
– If you attempt to set this command to ON and no table has been selected
using [SENSe[1]:]CORRection:CSET3[:SELect], then error –221,
“Settings conflict” occurs and [SENSe[1]:]CORRection:CSET3:STATe
remains OFF.
– If you set this command to ON and [SENS[1]:]CORRection:SGAMma:STATe
is currently ON, [SENS[1]:]CORRection:SGAMma:STATe will be set to OFF
and error –221, “Settings conflict; Single point gamma is being switched off”
occurs.
CORR:CSET3:STAT? Queries the current state of the Table-Based Gamma
correction.