12 TRIGger Subsystem
304 U8480 Series Programming Guide
INITiate[1]:CONTinuous:ALL <boolean>
Sets all trigger sequences to be continuously initiated.
If INITiate[1]:CONTinuous:ALL is set to:
– ON, trigger sequences are set to be continuously initiated
– OFF, trigger sequences are not set to be continuously initiated
Syntax
Example
Reset condition
On reset (*RST), this command is set to OFF.
On preset (SYSTem:PRESet) and U8480 Series power-up, this command is
set to ON.
INIT:CONT:ALL ON This command sets all trigger sequences to
be continuously initiated.
INIT
:CONT
0|OFF
1|ON
Space
?
:ALL
To Next Page
Loading...