Keysight U8480 Series - Calibration[1][:All]

4 CALibration Subsystem
118 U8480 Series Programming Guide
CALibration[1][:ALL]?
When the calibration sequence has completed, 0 or 1 is entered into the output
buffer to indicate if the sequence was successful. If the result is:
– 0, the calibration has passed
– 1, the calibration has failed
Syntax
Query example
Error messages
– If calibration was not carried out successfully, the error
–231, “Data Questionable; CAL ERROR” occurs.
– If zeroing was not carried out successfully, the error –231, “Data Questionable;
ZERO ERROR” occurs.
NOTE
This query is identical to CALibration[1][:ALL]; however, unlike the command,
it provides a response to indicate whether the calibration has been successful or
not.
CAL? Causes the U8480 Series to perform a calibration sequence, and
returns a result.
:ALL
?
CAL
1