10 STATus Subsystem
262 U8480 Series Programming Guide
Status Register Set Commands
This section describes the five status register set commands. Each can be used to
examine all of the status registers listed on page 261.
To apply a command to a specific register, prefix the command with the name of
the appropriate register. For example, to apply the :ENABle command to the
STATus:QUEStionable register, use the following command:
STATus:QUEStionable:ENABle
The status register set commands detailed in this section are as follows:
:CONDition?
This query returns a 16-bit decimal-weighted number representing the bits set in
the condition register of the SCPI register set you require to control. The format of
the return is <NR1> in the range of 0 to 32767 (2
15
–1). The contents of the
condition register remain unchanged after it is read.
Syntax
Keyword Parameter form Notes Page
:CONDition? [query only] page 262
:ENABle <NRf>|<non-decimal numeric> page 263
[:EVENt?] [query only] page 263
:NTRansition <NRf>|<non-decimal numeric> page 264
:PTRansition <NRf>|<non-decimal numeric> page 265
To Next Page
Loading...