Keysight U8480 Series - Page 263

STATus Subsystem 10
U8480 Series Programming Guide 263
[:EVENt]?
This query returns a 16-bit decimal-weighted number representing the bits set in
the event register of the SCPI register set you require to control. The format of the
return is <NR1> in the range of 0 to 32767 (2
15
–1). This query clears all bits in the
register to 0.
Syntax
:ENABle <NRf>|<non-decimal numeric>
This command sets the enable register of the particular SCPI register set you
require to control. The parameter value, when rounded to an integer and
expressed in base 2, has its first 15 bits written into the enable register of the SCPI
register set concerned. The last bit (bit 15) is always set to 0.
Syntax
Parameters
:EVEN
?
:ENAB NRf
non-decimal numeric
?
space
Type Description Range of values
NRf
The value used to set the enable register
0 to 2
15
–1
non-decimal numeric