TRIGger Subsystem 12
U8480 Series Programming Guide 301
INITiate[1]:CONTinuous <boolean>
This command sets the U8480 Series for either a single trigger cycle or
continuous trigger cycles. A trigger cycle means that the U8480 Series exits the
wait-for-trigger state and starts a measurement.
If INITiate[1]:CONTinuous is set to:
– OFF, the trigger system remains in the idle state until it is set to ON or
INITiate[1][:IMMediate] is received. Once this trigger cycle is complete, the
trigger system returns to the idle state.
– ON, the trigger system is initiated and exits the idle state. On completion of
each trigger cycle, the trigger system immediately commences another trigger
cycle without entering the idle state.
Syntax
Example
This command performs the same function as
INITiate[1]:CONTinuous:SEQuence[1] <boolean>.
INIT
1
:CONT 0|OFF
1|ON
Space
?
INIT:CONT ON This command places the U8480 Series in
the wait-for-trigger state.
To Next Page
Loading...