12 TRIGger Subsystem
302 U8480 Series Programming Guide
Reset condition
On reset (*RST), this command is set to OFF.
On preset (SYSTem:PRESet) and U8480 Series power-up,
INITiate[1]:CONTinuous is set to ON.
Query
INITiate[1]:CONTinuous?
The query enters a 1 or 0 into the output buffer.
– 1 is returned when there is continuous triggering
– 0 is returned when there is only a single trigger
Query example
INIT:CONT? Queries whether the U8480 Series is set for
single or continuous triggering.
To Next Page
Loading...