Keysight U8480 Series - [Sense[1]:]Correction:cset2[:Select] <String

8 SENSe Subsystem
190 U8480 Series Programming Guide
[SENSe[1]:]CORRection:CSET2[:SELect] <“string”>
This command enters the name of the frequency-dependent offset table which is
to be used.
Syntax
Parameters
Example
Reset condition
On reset, the selected table is not affected.
NOTE
If [SENSe[1]:]CORRection:CSET2:STATe is set to OFF, the selected
frequency-dependent offset table is not being used.
Item Description/Default Range of values
string
String data representing a frequency-dependent
offset table name.
Any existing table name
(Existing table names can be listed using
MEMory:CATalog:TABLe?).
CORR:CSET2 “PW1” This command enters the name of the
frequency-dependent offset table which is to be used.
SENS
1
:CSET2
CORR
:
?
:SEL
“string”
Space