Keysight U8480 Series - Memory:table Commands

6 MEMory Subsystem
154 U8480 Series Programming Guide
MEMory:TABLe Commands
These commands are used to define a frequency-dependent offset table, a
Gamma table, or an S-Parameter table, and to write to and read data from it.
The following commands and queries are described in this section:
MEMory:TABLe:FREQuency <numeric_value>{,<numeric_value>}
MEMory:TABLe:FREQuency:POINts?
MEMory:TABLe:GAIN[:MAGNitude] <numeric_value>{,<numeric_value>}
MEMory:TABLe:GAIN[:MAGNitude]:POINts?
MEMory:TABLe:MOVE <“character_data”>,<“character_data”>
MEMory:TABLe:SELect <“character_data”>
MEMory:TABLe:SGAMma <numeric_value>,<numeric_value>
{,<numeric_value>}{,<numeric_value>}
MEMory:TABLe:SGAMma:POINts?
MEMory:TABLe:SPARam
<S11|S12|S21|S22>,<numeric_value>,<numeric_value>
{,<numeric_value>}{,<numeric_value>}
MEMory:TABLe:SPARam:POINts? <S11|S12|S21|S22>