Keysight U8480 Series - Table 11-1 Default: U8480 Series Presets

SYSTem Subsystem 11
U8480 Series Programming Guide 293
Preset values
DEFault
Table 11-1 shows the U8480 Series presets when <character_data> is set to
DEFault or omitted.
Table 11-1 DEFault: U8480 Series presets
Command Setting Comment
CALC[1]:FEED[1] “POW:AVER” Select average measurement type
CALC[1]:LIM:CLE:AUTO ON Clear limit data at INIT
CALC[1]:LIM:LOW[:DATA] –90 dBm Lower limit
CALC[1]:LIM:STAT OFF Limits checking disabled
CALC[1]:LIM:UPP[:DATA] +90 dBm Upper limit
CALC[1]:MATH[:EXPR] “(SENS1)” Math expression
FORM[:READ]:BORD NORMal Binary order
FORM[:READ][:DATA] ASCii Data format
INIT[1]:CONT *RST: OFF
SYST:PRES: ON
U8480 Series in idle state
U8480 Series in wait-for-trigger state
MEM:TABL:SEL
not affected
Active frequency-dependent offset
table
[SENS[1]:]AVER:COUN 4 Filter length
[SENS[1]:]AVER:COUN:AUTO ON Auto-filtering enabled
[SENS[1]:]AVER:SDET 1 Step detection enabled
[SENS[1]:]AVER[:STAT] ON Averaging enabled
[SENS[1]:]CORR:CSET2[:SEL]
not affected
Selected frequency-dependent offset
table
[SENS[1]:]CORR:CSET2:STAT
not affected
Frequency-dependent offset table
disabled
[SENS[1]:]CORR:FDOF|GAIN4[:INP][:MAGN] not affected Return frequency-dependent offset
[SENS[1]:]CORR:GAIN2:STAT OFF Channel offset disabled
[SENS[1]:]CORR:GAIN2[:INP][:MAGN] 0.0 dB Enter channel offset value