Keysight U8480 Series - Page 294

11 SYSTem Subsystem
294 U8480 Series Programming Guide
[SENS[1]:]FREQ[:CW|:FIX] +50.000 MHz Frequency setting
SENSe[1]:]CORRection:CSET3:STATe
OFF
Table-based Gamma Correction
disabled
SENSe[1]:]CORRection:SGAMma:STATe
OFF
Single Point Gamma Correction
disabled
SENSe[1]:]CORRection:CSET4:STATe OFF S-Parameters Correction disabled
SENSe[1]:]CORRection:SGAMma:MAGNitude 0.0 Single Point Gamma magnitude
SENSe[1]:]CORRection:SGAMma:PHASe 0.0 Single Point Gamma phase
SENSe[1]:]MUNC:STATe OFF Real-Time MU disabled
SENSe[1]:]MUNC:SGAMma:TYPE SINGle Gamma type for Real-Time MU
[SENS[1]:]MRAT NORMal Measurement speed
TRIG[1]:DEL:AUTO ON Enable settling time delay
TRIG[:SEQ]:SLOP POSitive Trigger event recognized on rising edge
TRIG[:SEQ[1]]:COUN 1 Trigger events for measurement cycle
TRIG[:SEQ[1]]:DEL:AUTO ON Enable settling time delay
TRIG[:SEQ[1]]:SOUR IMMediate Trigger source setup
UNIT:POW dBm Power units
Command Setting Comment