Keysight U8480 Series - 6 Memory Subsystem; Memory Command Subsystem

MEMory Subsystem 6
U8480 Series Programming Guide 133
MEMory Command Subsystem
The MEMory command subsystem is used to:
– edit and review frequency-dependent offset tables.
– store frequency-dependent offset tables.
– edit and review save/recall registers.
– edit and review Gamma tables.
– store Gamma tables.
– edit and review an S-Parameter table.
– store an S-Parameter table.
Stored tables remain in the U8480 Series memory during power down. The U8480
Series is capable of storing 10 frequency-dependent offset tables of 80 frequency
points each, 3 Gamma Tables of 1024 frequency points each, and an S-Parameter
table of 1024 points.