Keysight U8480 Series - Memory:table:frequency <Numeric_Value>{,<Numeric_Value; Table 6-1 Frequency and Offset Factor List; Table 6-2 Gamma Frequency, Magnitude, and Phase List; Table 6-3 S-Parameter Frequency, Magnitude, and Phase List

MEMory Subsystem 6
U8480 Series Programming Guide 155
MEMory:TABLe:FREQuency <numeric_value>{,<numeric_value>}
This command is used to enter frequency data into the currently selected table.
Any previous frequency list is cleared before the new frequency list is stored. The
frequencies must be entered in the ascending order. Entries in the frequency lists
correspond with:
– entries in the offset factor lists, as shown in Table 6-1.
– entries in the magnitude and phase lists, as shown in Table 6-2.
– entries under S11, S12, S21, and S22, as shown in Table 6-3.
Table 6-1 Frequency and offset factor list
Table 6-2 Gamma frequency, magnitude, and phase list
Table 6-3 S-Parameter frequency, magnitude, and phase list
Frequency Offset
Frequency 1 Offset 1
""
Frequency 80 Offset 80
Frequency Magnitude Phase
Frequency 1 Magnitude 1 Phase 1
"" "
Frequency 1024 Magnitude 1024 Phase 1024
Frequency S11 S12 S21 S22
Frequency 1
Magnitude 1 Magnitude 1 Magnitude 1 Magnitude 1
Phase 1 Phase 1 Phase 1 Phase 1
"""""
Frequency 1024
Magnitude 1024 Magnitude 1024 Magnitude 1024 Magnitude 1024
Phase 1024 Phase 1024 Phase 1024 Phase 1024