14 IEEE-488.2 Command Reference
340 U8480 Series Programming Guide
*RCL <NRf>
The *RCL <NRf> (ReCaLl) command restores the state of the U8480 Series from
the specified save or recall register. A sensor setup must have been stored
previously in the specified register.
Syntax
Parameters
Error message
If the register does not contain a saved state, error –224, “Illegal parameter value”
occurs.
Type Description/Default Range of values
NRf The number of the register to be recalled. 1 to 10
To Next Page
Loading...