STATus Subsystem 10
U8480 Series Programming Guide 273
STATus:OPERation:TRIGger[:SUMMary]
The operation status trigger summary register set contains information on the
trigger status of the U8480 Series.
The following bit in these registers is used by the U8480 Series:
Bit 1 is set when the U8480 Series enters the “wait for trigger” state.
This bit is cleared when the U8480 Series enters the “idle” state.
Syntax
Bit number Decimal weight Definition
0-Not used
1 2 TRIGger status
2 to 15 - Not used (bit 15 is always 0)
To Next Page
Loading...