TRIGger Subsystem 12
U8480 Series Programming Guide 317
TRIGger[:SEQuence]:DELay <numeric_value>
This command sets the delay between the recognition of a trigger event and the
start of a measurement.
Syntax
Parameters
Example
Reset condition
On reset, the trigger delay is set to 0 seconds.
Item Description/Default Range of Values
numeric_value
The delay between the recognition of a trigger event and the start
of the measurement:
– DEF: the default value is 0 s
– MIN:
0 s
– MAX: 1 s
Units are resolved to 10 µs.
0 to 1 s
DEF
MIN
MAX
TRIG:SEQ:DEL 0.001 This command sets a delay of 1 ms for the
U8480 Series.
:DEL
TRIG
:SEQ
Space
?
numeric_value
DEF
MIN
MAX
MIN
MAX
Space
To Next Page
Loading...