Keysight U8480 Series - [Sense[1]:]Correction:cset2:State <Boolean

8 SENSe Subsystem
192 U8480 Series Programming Guide
[SENSe[1]:]CORRection:CSET2:STATe <boolean>
This command enables and disables the use of the currently active
frequency-dependent offset table (CSET2). When a table has been selected and
enabled, the frequency-dependent offsets stored in it can be used by specifying
the required frequency using the [SENSe[1]:]FREQuency[:CW|:FIXed]
command.
When the CSET2 command is set to ON, the frequency-dependent offset is taken
from the frequency-dependent offset table.
Syntax
Example
Reset condition
On reset, the selected table is not affected.
CORR:CSET2:STAT 1 This command enables the use of the
currently active frequency-dependent offset
table.
SENS
1
:CSET2CORR
:
:STAT
0|OFF
1|ON
Space
?