Keysight U8480 Series - TRIGger[1]:SOURce BUS|EXTernal|HOLD|IMMediate

12 TRIGger Subsystem
314 U8480 Series Programming Guide
TRIGger[1]:SOURce BUS|EXTernal|HOLD|IMMediate
This command configures the trigger system to respond to the specified source.
This command only selects the trigger source. Use the INITiate[1][:IMMediate]
command to place the U8480 Series in the wait-for-trigger state.
Syntax
NOTE
This command has been included for compatibility purposes. It has the same
purpose as TRIGger[:SEQuence[1]]:SOURce BUS|EXTernal|HOLD|IMMediate
which should be used in preference.
TRIG
:SOUR
1
BUS
Space
EXT
HOLD
?
IMM