Keysight U8480 Series User Manual

6 MEMory Subsystem
162 U8480 Series Programming Guide
MEMory:TABLe:MOVE <“character_data”>,<“character_data”>
This command is used to rename a frequency-dependent offset table, a Gamma
table, or an S-Parameter table.
Syntax
Parameters
Example
Error messages
– If either table names are invalid, error –224, “Illegal parameter value” occurs.
– If the first parameter does not match an existing table name, error –256, “File
name not found” occurs.
– If the second parameter matches an existing table name or a save/recall
register, error –257, “File name error” occurs.
Item Description/Default Range of values
character_data
(1st parameter)
Contains the existing table name. Existing table name.
character_data
(2nd parameter)
Details the new table name. A maximum of 12 characters
can be used.
A to Z (uppercase)
a to z (lowercase)
0 to 9_ (underscore)
MEM:TABL:MOVE “tab1”,”tab1a” This command renames a table named
tab1 to tab1a.
MEM
:TABL
:MOVE
,
Space
“character_data”
“character_data”

Keysight U8480 Series Specifications

General

Brand	Keysight
Model	U8480 Series
Category	Accessories
Language	English