U8480 Series Remote Operation 1
U8480 Series Programming Guide 45
Setting Offsets
Channel offsets
The U8480 Series can be configured to compensate for signal loss or gain in your
test setup (for example, to compensate for the loss of a 10 dB attenuator). You use
the SENSe command subsystem to configure the U8480 Series. Gain and loss
correction are a coupled system. If you enter an offset value, the state is
automatically enabled. However, it can be enabled and disabled using the
[SENSe[1]:]CORRection:GAIN2:STATe <boolean> command.
To enter a LOSS value, you can enter a negative value in the command:
[SENSe[1]:]CORRection:GAIN2[:INPut][:MAGNitude] <numeric_value>
To Next Page
Loading...