Keysight U8480 Series - Service:sensor[1]:Cplace <Place

9 SERVice Subsystem
246 U8480 Series Programming Guide
SERVice:SENSor[1]:CPLace <“place”>
This command is used to enter the place of calibration of the U8480 Series. A
maximum of eight alphanumeric characters can be entered.
Syntax
Example
Query
SERVice:SENSor[1]:CPLace?
This query returns a string specifying the place of calibration of the U8480 Series,
as stored in the non-volatile memory.
Query example
SERV:SENS:CPL “Keys-Pen” This command enters the place of
calibration as Keysight Penang.
SERV
1
:CPL
:SENS
“place”
?
Space
SERV:SENS:CPL? Returns the U8480 Series place of calibration.
NOTE
If the place of calibration is not pre-programmed, “NONE” is returned.