Keysight U8480 Series - Page 261

STATus Subsystem 10
U8480 Series Programming Guide 261
Each of these can be used to examine any of the following status registers:
STATus:DEVice (page 266)
STATus:OPERation (page 268)
STATus:OPERation:CALibrating[:SUMMary] (page 269)
STATus:OPERation:LLFail[:SUMMary] (page 270)
STATus:OPERation:MEASuring[:SUMMary] (page 271)
STATus:OPERation:SENSe[:SUMMary] (page 272)
STATus:OPERation:TRIGger[:SUMMary] (page 273)
STATus:OPERation:ULFail[:SUMMary] (page 274)
STATus:QUEStionable (page 277)
STATus:QUEStionable:CALibration[:SUMMary] (page 278)
STATus:QUEStionable:POWer[:SUMMary] (page 279)
Examples
–To use the :CONDition? command to examine the STATus:DEVice register:
STATus:DEVice:CONDition?
–To use the :NTRansition command to examine the
STATus:OPERation:SENSe[:SUMMary] register:
STATus:OPERation:SENSe[:SUMMary]:NTRansition