Kia CADENZA 2020 - Windshield Wipers & Washers; Lifting Wipers;Wiper Service Mode

23
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
*IF EQUIPPED
MIST: Single wipe
OFF: Wiper off
AUTO: Auto Control wipe
LO: Slow wipe
HI: Fast wipe
FRONT
A
B
Windshield Wipers & Washers
To operate:
• Move lever Up/Down to change Wiper modes
• Press button
A
to adjust intermittent Wipe
• Pull lever to spray and wipe
Auto Control (Rain Sensing)
The rain sensor located on the upper end of the windshield
glass is designed to sense the amount of rainfall and controls
the wiping cycle for the proper interval. The more it rains, the
faster the wiper operates. When the rain stops, the wiper stops.
To adjust the Auto Rain Sensing speed setting, move the speed
control switch
A
up/down.
Lifting Wipers / Wiper Service Mode
To inspect or replace the windshield wiper blades to prevent damaging the hood, the
blades need to be moved to the service position
A
.
With the ignition ON, then turning the ignition OFF, within 20 seconds move the wiper
switch to the MIST position
B
and hold the switch for more than two seconds until the
wiper blade is in the fully up position.
To return wipers to normal position, turn the ignition ON, then activate MIST.
• With the ENGINE START/STOP button in the ON position and
the wiper switch is in AUTO mode, the wiper will operate once
to perform a self-check of the system
• Moving lever to HI increases Intermittent wipe frequency and
wipe speed. Moving lever to LO decreases frequency of wipes.
• When in AUTO mode, pressing button
A
up increases
Intermittent wipe frequency and wipe speed. Pressing button
down decreases frequency of wipes
• Set the wiper to OFF position when the wiper is not in use
QUICK TIPS
STEERING WHEEL CONTROLS