413
Features of your vehicle
• Lock the doors by pressing the lock
button on the smart key.
After completion of the steps above,
the hazard warning lights will operate
once to indicate that the system is
armed.
If any door (and trunk) or engine bon-
net remains open, the hazard warn-
ing lights won't operate and theft-
alarm will not arm. After this, if all
doors (and trunk) and engine bonnet
are closed, the hazard warning lights
blink once.
Using the transmitter
Park the vehicle and stop the engine.
Arm the system as described below.
1.Turn off the engine and remove the
ignition key from the ignition switch.
2.Make sure that all doors (and trunk),
the engine bonnet are closed and
latched.
3.Lock the doors by pressing the lock
button on the transmitter.
After completion of the steps above,
the hazard warning lights will blink
once to indicate that the system is
armed.
If any door (and trunk) or engine bon-
net remains open, the hazard warning
lights won't operate and theft-alarm will
not arm. After this, if all doors (and
trunk) and engine bonnet are closed,
the hazard warning lights blink once.
• Do not arm the system until all pas-
sengers have left the vehicle. If the
system is armed whilst a passen-
ger(s) remains in the vehicle, the
alarm may be activated when the
remaining passenger(s) leave the
vehicle. If any door, trunk or engine
bonnet is opened within 30 seconds
after entering the armed stage, the
system is disarmed to prevent
unnecessary alarm.
Theft-alarm stage
The alarm will be activated if any of the
following occurs whilst the system is
armed.
• A door is opened without using the
transmitter (or smart key).
• The trunk is opened without using the
transmitter (or smart key).
• The engine bonnet is opened.
The horn will sound and the hazard
warning lights will blink continuously for
approximately 30 seconds. To turn off the
system, unlock the doors with the trans-
mitter (or smart key).
To Next Page
Loading...
