329
Safety features of your vehicle
Pull the metal tab (B) and insert it (B)
into the buckle (B’). There will be an
audible “click” when the tab locks into
the buckle. Make sure the belt is not
twisted.
When using the rear centre seat belt
the buckle with the “CENTER” mark
must be used.
✽✽
NOTICE
If you are not able to pull out the
seat belt from the retractor, firmly
pull the belt out and release it. After
release, you will be able to pull the
belt out smoothly.
To release the seat belt:
The seat belt is released by pressing
the release button (A) in the locking
buckle. When it is released, the belt
should automatically draw back into
the retractor.
If this does not happen, check the
belt to be sure it is not twisted, then
try again.
WARNING
Always have the metal tab(A)
inserted into the buckle (A’).
OCK037024
OCK037025
OUM036100R
To Next Page
